Skip to main content

Showing NetSuite contact details as columns in the contacts table

Keep extra NetSuite values on contacts and show them as columns, filters and email recipient chips.

An extra column keeps one more NetSuite value on each contact that a contact rule makes, for example the site of the contact. The value shows as a column in the contacts table of the customer. You can also use it to filter contacts in workflows, and show it next to the contact when you choose email recipients.

Only company admins and the Kolleno team can open the NetSuite settings page. It is turned off by default. Contact your Customer Success Manager or Kolleno Support to enable it for your account.


Add an extra column

  1. Go to the NetSuite settings page and click Contacts.

  2. Open a contact rule.

  3. Open Advanced.

  4. Under Extra columns, click Add column.

  5. Fill in the column. The fields are in the table below.

  6. Click Save.

Field

What it does

Key

Kolleno stores the value under this key. Use lower-case letters, digits and underscores. Start with a letter. Rules with the same key share one column.

Label

The name of the column in the contacts table. Rules with the same key use one name.

Field

The NetSuite field that holds the value. When the rule follows a link, pick a field of the linked record.

Holds many values

Select this when one contact can have several values, for example several sites.

Show in email recipients

Kolleno shows the value next to the contact when you choose email recipients, for example "Sites: London, Leeds".

Up to 2 columns can show in email recipients, across all your rules. To show a different column, turn one off first.

Only the columns of enabled rules show in Kolleno.


Where the values show

The contacts table of a customer

  1. Open the customer.

  2. Click the Configuration tab.

  3. Click Customer contacts.

Each extra column shows after the Position column. A contact without a value shows --.

Filters and workflows

Each extra column is also a filter on contacts. Use it to filter contacts in workflows, for example to send an email only to the contacts of one site.

Email recipients

If Show in email recipients is on, the value shows as a chip next to the contact when you choose the recipients of an email.

Did this answer your question?